Author: Paul Vanderheyden December 21, 2008 at 16:39:23 from 98.27.51.39 in reply to: What size to tap 30mm hole for Aeroquip style fitting? posted by Chris Wilson on June 15, 2008 at 17:03:04
30mm is 1.180 inches, and the next size AN fitting would be a -16. This utilizes a 1.312 (1 5/15 x 12) thread. This is a straight thread, so you would have to install the fitting with either an annealed copper washer, or a combination copper/rubber washer.
Regards,
Paul
Post Followup
Note: Follow-ups should only be used for information of interest to all viewers. For other inquiries or personal communication please send an email if possible or use other contact information provided.
When you return to the board you will need to do a REFRESH or RELOAD to see your followup.