Author: Ja,mes Jordan May 19, 2008 at 21:24:01 from 72.197.71.55 in reply to: 711 M FF 1600cc Block posted by PF on May 6, 2008 at 22:49:13
Thanks simon
You may want to correct the web site.
James
From: office@qednet.demon.co.uk
To: jamesjordan@hotmail.com
The crank stroke should read 77.6mm. or as you say 77.62 to be exact.
regards
Simon.
-----Original Message-----
From: James Jordan [mailto:jamesjordan@hotmail.com]
Sent: 16 October 2007 22:56
To: office@qednet.demon.co.uk
Simon, Thanks for the reply. I was trying to reproduce the QED 1700 cc motor, Except for 83.5mm pistons. In your spec (from the web site) you list the crank stroke as 76.7 Is this correct?
I missed this the first time as i thought it was a standard 711M 77.62 stroke
Thanks
James
"1700cc Short Engine (Available on an outright sale basis)
A basic short engine assembly comprising a rebuilt Ford 711M block, bored to twincam (82.5mm) bore size. A 76.7mm crank is ground, laped and fitted (with appropriate bearings), along with 4.9" con rods and a set of new QED cast pistons. Jackshaft bearings are fitted as required and the block face is then machined to give the correct height.
Optionally this can be supplied with a new iron jackshaft, steel flywheel and ring gear, baffled sump and front cover assembly."
Post Followup
Note: Follow-ups should only be used for information of interest to all viewers. For other inquiries or personal communication please send an email if possible or use other contact information provided.
When you return to the board you will need to do a REFRESH or RELOAD to see your followup.