Excellent running 180bhp BDA in street tune. This motor is absolutely ready to "plug and play" and comes complete with flywheel, clutch, distributor (Pertronix), 45DCOE Webers, alternator, etc. It has 10.5:1 compression and runs great on pump gas. It was originally built by Dave Bean Engineering and was then rebuilt by Midwest Motorsports about 3,000 miles ago. I just removed it from my street Caterham and before removing it I did a leakdown test and all cylinders were under 3% so it is still in great shape. The bottom end has a fully counterweighted steel crank, Carillo rods, Cosworth pistons and steel main caps. It is dry sumped with a 5 port Titan pump and the head is a 3 bolt exhaust. You can use this motor "as-is" in a street car or use it in a race car as an "enduro" type motor as it will run forever in it's current state of tune. It is easily upgradeable to a full-on race motor with higher compression pistons and new cams. Also comes with the header and exhaust system from the Caterham to use as the basis of the exhaust for your application
Engine Builder: Dave Bean Engineering
Induction: twin 45DCOE Weber
Crankshaft: Steel Billet
Connecting Rods: Carillo
Includes header and exhaust system from Caterham street car to use as the basis for the exhaust system for your application.