Up for sale is a brand new out of the box Chrysler/Mitsubishi 420a turbo motor. Complete and ready to be dropped and go. This is a race built motor, mostly bought from slowboy racing in Florida, and was Professionally built by a mechanic. Also will include the stock 5 speed transmission and complete Greddy evo to exhaust. The fallowing is the specs- -Slowboy 420a stage 2 race block - brain crower 3/4 race cams and springs and retainers -slow boy stage 1 block - bored .020 over -wiseco pistons 10.5:1 compression -clevite rod and main bearings -ARP main rod bolts -Prothane complete motor mount kit and suspension mount kit -Aem stand alone complete engine management ecu - unorthodox racing crank pulley, alternator pulley, power steering pulley, all anodized - High flow oil pump -new water pump -engine fully timed and ready to go -new oil pan with turbo drain fitting -slowboy complete race fuel package ( fallowing is what comes in it ) - walbro 255 fuel pump - complete steel braided lines from tank to rail - areomotive pressure regulator and filter - obx high flow fuel rail - fuel lab 640cc injectors - fuel pressure gauge - all AN fittings included and most have been anodized to match the engine - accel 275+ IGN CD ignition system - e2 race spark plugs - vitek 8mm race spark plug wires - stock coil ( works best with accel 275+ ) - venom high flow intake manifold anodized ( all sensors and egr tube have been drilled out and installed ) - 55mm throttle body - all the steel intake piping from turbo to intercooler and then to intake manifold and couplings included - Slowboy 420a turbo package ( the fallowing came with kit ) - garret 57 trim 15psi t3/t4 turbo - slowboy racing large intercooler - aem tru boost, boost controller - Greddy type (s) BOV - tial external waste gate - oil feed and return lines and fittings - cone intake filter - slowboy racing cast turbo exhaust manifold - slow boy racing down pipe and flex pipe - all the fittings and pipping included - fluidyen racing radiator - fal racing puller fan - Mr. gasket coolant hoses both upper and lower - magna flow high flow cat converter - Greddy Evo 2 N1 exhaust ( has about 500 miles on it but is in perfect condition and looks new ) - spec stage 3+ race clutch and aluminum sly wheel - slow boy racing LSD - stock axles ( can hold up to 600whp ) - megans racing short shifter - slowboy racing ss clutch lines - Nitrous Express nx proton nitrous kit with a 10 lbs bottle and heater
this is a brand new motor built professionally, includes the stock 5 speed tranny that shifts and works perfectly. Engine built then stored over winter in a heated garage over the winter. Engine is complete, timed and ready to be dropped with out any work other than intake pipe fitment. Block itself was installed but nothing else, selling because i'm leaving for med school and don't have the time to finish the rest of the project.