1993 Reynard 93D Formula 3000 Mugen

Serial Number: tbd Engine Number: tbd Logbooks: tbd Condition: perfect Price: £32,000 GBP Location: England

Description This Reynard is in perfect condition with a 3 litre Mugen producing 470 Bhp. The car runs a '92 spec "H" pattern gearbox. The standard '93 fitment was a sequential 'box and the driver preferred being able to shift down, skipping gears. It is accompanied by enough spares to almost assemble a second car. The spares are listed below. The car features a full Astratech data logging system and is race ready.

History

Engine

• Mugen V8
• 3 litre
• 470 Bhp
• approximately 1/3 through life cycle
• carbon clutch

Oil/Water System

• sidepod rads

Electrical System

• Full Astratech data logging system

Gearbox

• 1992 spec "H" pattern gearbox replaces the '93 standard sequential box due to driver preference.
• all rear suspension mountings and pickup points remain the same

Body

• carbon

Chassis

• carbon
• Dampers: tbd
• Front Suspension: dual wishbone, pushrod
• Rear Suspension: pushrod
• Steering: rack

Spares

• 1 complete gearbox
• 1 tub
• 2 nose boxes
• 1 front wrng
• 3 rh front end plates
• 3 lh front end plates
• 1 rh front flap
• 1 lh front flap
• 1 rear main plane with pillars
• 1 engine cover
• 2 rh side pods
• 1 lh slde pod
• 1 rh radiator air duct
• 1 lh radiator air duct
• 1 fuel tank
• 2 nose covers
• 3 front floors
• 2 rear floors
• 4 wheel nuts
• 1 DFY installation kit (4 engine pick up points, studs, bottom, mounting plate)
• 1 front lh bottom wishbone
• 1 front rh bottom wishbone
• 1 front rh top wishbone
• 1 front pushrod
• 2 front track rods
• 2 rear top wishbones
• 1 rear bottom wishbone lh
• 2 rear pushrods with strain gauges
• 4 rear track rods
• 1 radiator
• 1 drive shaft
• 17 suspension pickup points (various)
• 4 big hubs for uprights (one hub complete with bearing mount and bearings)
• 10 wlre stays for nose
• 4 floor steel stays
• 3 disc bells
• 1 front mono bar
• 1 front bridge bar
• 1 dfy exhaust
• dfy water alloy pipes
• 8 rear wheels (big hub}
• 6 front wheels (big hub)
• 1 gearbox oil pump
• 2 front rockers
• 4 upright bearings
• 3 upright seals
• 2 dfy flywheels
• 3 cv covers
• 4 diff bearings
• 1 engine shaft
• 1 diff cv hub
• 2 diff rumps
• 3 diff discs
• 4 selector forks for gear box
• 2 selector fingers
• 1 reverse gear
• 1 battery mount
• 9 brake air ducts
• 10 set suspension springs
• 1 brake disc
• 1 alloy mount for master cylinders and front bottom wishbone
• 250 (approx) gear ratios (too many to count exactly)