Description
Car has a ton of stuff done to it but also has a lot of potential. Most of the parts listed were installed/purchased in 2005-2006. I have Just over $7k into it right now excluding the bodywork. I have spent all of my time on this car since I wrecked it in Dec of 2004. The front frame rails were bent to the right about and inch. A frame shop straightened everything out and the only noticeable spots of damage are the driver’s frame rail. It has a few dents from the AC and PS pulleys. NEEDS -Motor Install -Ignition Wire Up -Drivers Axle -Tranny rebuild (torn apart in a box right now) -EPROM chip for ECU -Tuning MOTOR (sitting on stand, freshly built) -Head Cleaning -Block Cleaning -Crank Polishing -Password JDM ABS Plastic Intake Mani Gasket -Unorthodox Racing Single Belt Crank Pulley -Honda/Acura P29 Pistons (~12:1 compression) -New Gaskets and seals -DC-Sports 4-2-1 One-piece header -2-1/4 inch cat back exhaust, no resonator -Magnaflow Muffler -Home made Poly filled Motor mount -New OEM Honda Oil Pump -New OEM Honda Oil pickup to pump gasket -New OEM Honda Water Pump -MSD 6AL ignition module -MSD Pro Cap distributor cap -MSD plug wires -MSD Blaster 2 coil -Honda CBR929 Home made ITB's w/ velocity stacks -Socketed P28 ECU setup for UBERdata w/ data logging -J's Racing Magnetic Oil Pan Drain Plug -Greddy Oil Catch Can DRIVELINE -ACT Streetlight Flywheel -Exedy Stage 2 Clutch Kit -New OEM Honda shift linkage boot -Energy Suspension Poly rear tranny mount insert -Homemade poly filled tranny mount -Homemade poly filled torque mounts -New Passenger side axle -Energy Suspension poly shift stabilizer bushings -Arospeed Short Shifter INTERIOR -Skunk2 10th anniversary weighted shift knob -Pilot Motor sports D-Shaped steering wheel -Custom 4-gauge pod -Autometer Oil pressure gauge (bad gauge, not working) -Autometer Water Temp Gauge -Autometer Volt Gauge -Autometer Air/Fuel Gauge -Sony 6.5" rear speakers (car only has rear speakers, not fronts) EXTERIOR -Shaved side molding -Fresh paint (Aug 2005) -Tow Hooks -OEM 4 door spoiler -JDM Yellow headlight bulbs -Sparco Hood Pins -Carbon Fiber Hood SAFETY -Fire Extinguisher (hand held unit, not a system) -RJS Black 5 point harness (not installed) SUSPENSION -JIC Carbon Fiber Rear Strut bar -APEXi front strut bar -Bomz Racing coil overs WHEELS -Lightweight 15" Konig Helium’s (11 lbs) SPARES/EXTRAS -OEM Interior trim -Black GSR rear seat -OEM springs -Washer reservoir -A/C system components -ECU wiring harness plugs -OEM Steelies w/ newer tires -Passenger side mirror -Trunk lid -Floor mats -Trunk carpet and cardboard -Spare tire, jack, and tools -OEM intake manifold, throttle body, IACV -OEM Flywheel -OEM Distributor cap and rotors -SLS Cold air intake -Cone filter -Misc bolts and brackets -Other misc interior -OEM steering wheel -OEM driver’s air bag -Suzuki GSXR throttle bodies (look like 650, but not sure)
